Filter
Top Products
VLAN Commands
360 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
switchport mode
The switchport mode Interface Configuration mode command configures the VLAN
membership mode of a port. To return to the default configuration, use the
no form of this
command.
Syntax
switchport mode {access | trunk | general}
no switchport mode
Parameters
• access — Indicates an untagged layer 2 VLAN port.
• trunk — Indicates a trunking layer 2 VLAN port.
• general — Indicates a full 802-1q supported VLAN port.
Default Configuration
All ports are in access mode, and belong to the default VLAN (whose VID=1).
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines.
Example
The following example configures Ethernet port 1 as an untagged layer 2 VLAN port.
switchport access vlan
The switchport access vlan Interface Configuration mode command configures the
VLAN ID when the interface is in access mode. To return to the default configuration, use
the
no form of this command.
Console(config)# interface ethernet ext.1
Console(config-if)# switchport mode access