Filter
Top Products
SNMP Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 247
Command Mode
Global Configuration mode
User Guidelines
When configuring an SNMPv1 or SNMPv2 notification recipient, a notification view for
that recipient is automatically generated for all the MIB.
When configuring an SNMPv1 notification recipient, the
Inform option cannot be
selected.
If a trap and inform are defined on the same target, and an inform was sent, the trap is not
sent.
Example
The following example enables SNMP traps for host 10.1.1.1 with community string
"management" using SNMPv2.
snmp-server v3-host
The snmp-server v3-host Global Configuration mode command specifies the recipient of
Simple Network Management Protocol Version 3 notifications. To remove the specified
host, use the
no form of this command.
Syntax
snmp-server v3-host {ip-address | hostname} username [traps | informs] {noauth |
auth | priv
} [udp-port port] [filter filtername] [timeout seconds] [retries retries]
no snmp-server host {ip-address | hostname} username [traps | informs]
Parameters
• ip-address — Specifies the IP address of the host (targeted recipient).
• hostname — Specifies the name of the host. (Range:1-158 characters)
• username — Specifies the name of the user to use to generate the notification.
(Range: 1-24)
• traps — Indicates that SNMP traps are sent to this host.
• informs — Indicates that SNMP informs are sent to this host.
• noauth — Indicates no authentication of a packet.
Console(config)# snmp-server host 10.1.1.1 management 2