Filter
Top Products
132
(45)Transistor output monitor ON delay time setting (Un\G175)
Set the delay time of the ON delay output flag.
Set this buffer memory area to perform the heater disconnection detection with other input modules provided on
the system.
For ON delay output flag, refer to the following.
Page 92, Section 3.4.2 (7)
For details on the ON delay output function, refer to the following.
Page 222, Section 4.17
(a) Setting range
The setting range is 0 or 1 to 50 (10 to 500ms).
When 0 is set, ON delay output flag is not set to 1 (ON).
(b) Default value
The default value is set to 0.
(46)CT monitor method switching (Un\G176)
Set the method for performing the heater current measurement.
(a) Supported modules
•Q64TCTTBWN
•Q64TCRTBWN
(b) Setting range
• 0: ON/OFF current
• 1: ON current
When ON/OFF current (0) is set, the present current value of the current sensor (CT) is measured.
Selecting ON current (1) fixes the current value of the heater being OFF as the current value of the heater
previously being ON.
(c) Default value
The default value is set to ON/OFF current (0).
Common
Common