Filter
Top Products
317
CHAPTER 7 PROGRAMMING
7
7.2 When Using the Module in a Standard System Configuration
7.2.1 Standard control (such as auto tuning, self-tuning, and error code read)
(b) Program example
• Program that changes the setting/operation mode
This program is the same as that of when the parameter of the intelligent function module is used.
( Page 315, Section 7.2.1 (6) (f))
• Initial setting program
*1 Configure this setting only when the self-tuning function is used.
CH2 Unused channel setting: Unused
CH3 Unused channel setting: Unused
CH4 Unused channel setting: Unused
CH1 Unused channel setting: Used
CH1 Input range: 2
CH1 Alert 1 mode setting: Upper
input alert
CH1 Control output cycle
setting: 30s
CH1 Self-tuning setting: Starting
ST (PID constants only)
Setting change instruction: ON
Setting change instruction: OFF
Flag 2 for setting value write: ON
CH1 Alert set value 1: 250
CH1 Set value (SV) setting: 200
CH1 Upper limit setting limiter: 400
CH1 Lower limit setting limiter: 0
Flag 2 for setting value write: OFF
Flag 1 for setting value write: OFF
*1
Flag 0 for setting value write: ON
Flag 1 for setting value write: ON