Mitsubishi Electronics Q64TCTTBWN Network Card User Manual


 
374
APPENDICES
Appendix 1 Addition and Change of Functions
Appendix 1.1 Additional function
The following table shows the function added to the Q64TCN and the product information of the Q64TCN that supports
the additional function.
Appendix 1.2 Change of functions
The following table shows the changed functions of the Q64TCN and the product information of the Q64TCN that
supports the changed functions.
(1) Function extension bit monitor (Un\G787)
The following contents set in the intelligent function module switch setting are stored.
"Auto-setting at Input Range Change"
"Setting Change Rate Limiter"
"Moving Averaging Process Setting"
(a) When using the Q64TCN that does not support this function
Because the module does not support "Moving Averaging Process Setting", setting contents of "Moving
Averaging Process Setting" cannot be checked.
(2) Intelligent function module switch setting
Whether to perform the moving averaging process can be selected in the intelligent function module switch
setting.
(a) When using the Q64TCN that does not support this function
The moving averaging process setting cannot be configured in the intelligent function module switch setting.
Additional function Product information Applicable GX Works2 version Reference
Moving averaging process to a
temperature process value (PV)
The first five digits are
14062 or later.
1.91V or later Page 191, Section 4.10
During AT loop disconnection
detection function
The first five digits are
15042 or later.
1.501X or later Page 255, Section 4.23
Changed function Product information Applicable GX Works2 version Reference
Function extension bit monitor
(Un\G787)
The first five digits are
14062 or later.
1.91V or later
Page 374, Appendix 1 (1)
Intelligent function module switch
setting
Page 374, Appendix 1 (2)