Filter
Top Products
298
CHAPTER 6 VARIOUS SETTINGS
This chapter describes the setting procedures of the Q64TCN.
● To enable the contents of the new module, parameter setting, and auto refresh setting, reset the CPU module, switch
STOP RUN STOP RUN, or turn off and on the power after writing the contents into the CPU module.
● To enable the contents of the switch setting, reset the CPU module, or turn off and on the power after writing the contents
into the CPU module.
6.1 Addition of Modules
Add the model name of the Q64TCN to use on the project.
(1) Addition procedure
Open the "New Module..." window.
Project window [Intelligent Function Module] Right-click [New Module...]
Item Description
Module
Selection
Module Type Set "Temperature Control Module".
Module Name Select the module model name to mount.
Setting Item
Reduction Mode for
Auto-refresh
Select it to reduce the number of setting items for auto refresh.
( Page 303, Section 6.4)
Mount
Position
Base No. Set the base unit where the module is mounted.
Mounted Slot No. Set the slot No. where the module is mounted.
Specify start XY
address
The start I/O number (hexadecimal) of the target module is set, according to the slot
No. An arbitrary start I/O number can be also set.
Title setting Title Set an arbitrary title.