Filter
Top Products
277
CHAPTER 5 SETTINGS AND THE PROCEDURE BEFORE OPERATION
5
5.2 Settings and the Procedure before Operation
5.2 Settings and the Procedure before Operation
The following figure shows the procedure before operating the Q64TCN.
When using the Q64TCTTN and the Q64TCTTBWN which use the thermocouples as the temperature sensors, temperature
compensation must be executed properly. Perform warm-up operation about 15 minutes before starting operation.
Start
Operation
Mounting the module
Mount the Q64TCN in a slot.
Wiring
Wire external devices to the Q64TCN.
Switch setting
Configure settings using GX Works2.
Execution of auto tuning
Configure auto tuning to set PID constants.
Execution of auto tuning
Configure auto tuning to set PID constants.
Configure the initial setting?
Initial setting
Configure the initial setting using GX Works2.
Auto refresh setting
Configure the auto refresh setting using GX Works2.
Programming
Create and check a program without using
the FROM/TO instructions.
Warmup operation
(when the Q64TCTTN or the Q64TCTTBWIN is used)
Configure warmup operation about 15 minutes before
starting operation.
YES
NO
Configure the initial setting
and the auto refresh setting using
GX Works2?
YES
NO
Configure
the auto refresh setting?
YES
NO
Programming
Create and check a program without using
the FROM/TO instructions.
Initial setting
Create a sequence program for writing initial values
using the FROM/TO instructions.
Configure the initial setting?
YES
NO
Page 287, Section 5.4
Page 299, Section 6.2
Page 306, CHAPTER 7
Page 303, Section 6.4
Page 179, Section 4.6 (5) (a)
Page 306, CHAPTER 7
Page 306, CHAPTER 7
Page 300, Section 6.3
Page 183, Section 4.6 (5) (b)