Filter
Top Products
328
(f) Program example where the peak current suppression function or the simultaneous
temperature rise function is used
• Program that changes the setting/operation mode
This program is the same as that of when the module is in the standard control (such as auto tuning, self-
tuning, and error code read). ( Page 315, Section 7.2.1 (6) (f))
• Program that stops the auto tuning when an alert is detected
• Program that reads the PID constants from E
2
PROM
• Program that reads an error code
CH1 Auto tuning instruction: OFF
CH2 Auto tuning instruction: OFF
CH3 Auto tuning instruction: OFF
CH4 Auto tuning instruction: OFF
CH1 E
2
PROM's PID constants read
instruction: Requested
CH1 E
2
PROM's PID constants read
instruction: Not requested
CH2 E
2
PROM's PID constants read
instruction: Requested
CH3 E
2
PROM's PID constants read
instruction: Requested
CH4 E
2
PROM's PID constants read
instruction: Requested
CH2 E
2
PROM's PID constants read
instruction: Not requested
CH4 E
2
PROM's PID constants read
instruction: Not requested
CH3 E
2
PROM's PID constants read
instruction: Not requested
Read bit data from b7 to b0 of E
2
PROM's
PID constants read/write completion flag to
M20 to M27.
Output a write data error code to
Y60 to Y6F.
Error reset instruction: ON
Error reset instruction: OFF