Filter
Top Products
333
CHAPTER 7 PROGRAMMING
7
7.2 When Using the Module in a Standard System Configuration
7.2.2 Standard control (peak current suppression function, simultaneous temperature rise function)
• Program that executes the auto tuning and backs up the PID constants in E
2
PROM if the auto tuning is
normally completed (The auto tuning is stopped when an alert is detected.)
This program is the same as that of when the peak current suppression function is used. ( Page 330,
Section 7.2.2 (7) (b))
• Program that reads the PID constants from E
2
PROM
This program is the same as that of when the parameter of the intelligent function module is used.
( Page 328, Section 7.2.2 (6) (f))
• Program that reads an error code
This program is the same as that of when the peak current suppression function is used. ( Page 330,
Section 7.2.2 (7) (b))
CH1 Alert set value 1: 250
CH2 Alert set value 1: 300
CH3 Alert set value 1: 350
CH4 Alert set value 1: 400
CH1 Set value (SV) setting: 200
CH2 Set value (SV) setting: 250
CH3 Set value (SV) setting: 300
CH4 Set value (SV) setting: 350
Flag 1 for setting value write: OFF
Flag 2 for setting value write: OFF