Mitsubishi Electronics Q64TCTTBWN Network Card User Manual


 
395
APPENDICES
A
Appendix 4 Online Module Change Procedure (When Using GX Developer)
Appendix 4.5 When GX Configurator-TC was used for the initial setting
(5) Restarting control
(From the previous page)
3. Click to close the
"System Monitor" window.
4. Before restarting the control, check the following
items for the Q64TCN. If an error occurs, refer to
TROUBLESHOOTING ( Page 359, CHAPTER 8)
and take corrective action.
If the RUN LED is on.
If the ERR. LED is off.
If Write error flag (Xn2) is off.
If Hardware error flag (Xn3) is off.
1. Open the "Online module change" window again.
[Diagnostics] [Online module change...]
2. When the window appears, click to restart
the control. Module READY flag (Xn0) turns on.
3. The online module change is complete.