Filter
Top Products
OPTIONAL FUNCTIONS
100
2
-
--
-
Notes about drawing a command sheet
The image might differ depending on how the designated area is drawn, so re-
member the following when making the command sheet:
Designated area Area recognized Preferred designated area
Part of the designated area
is surrounded by 3 sides of
the entire area.
Make a space of at least 2 mm,
0.08", in front of the area sur-
rounded by 3 sides (relative to
the feed direction).
1, 2 = 2 mm, 0.08"
Double line pattern. Only the outer line is
recognized.
Make a gap of at least 2 mm, 0.08"
in width.
The designated area is sur-
rounded by 3 sides of an-
other designated area.
Make a space of at least 2 mm,
0.08" in front of the area sur-
rounded by 3 sides (relative to
the feeding direction).
1, 2 = 2 mm, 0.08"
Non-closed line
Designate the area with a closed line.
12
1
2