Filter
Top Products
Troubleshooting
168
5
-
--
-When a service call message is shown on the panel display
Press the [Exit] key. Then turn the main switch off and back on again. If a service
code appears again, contact your service representative.
Note
❒ If a service code appears on the panel display after you turn the main switch
off and on a few times, do not continue turning it on and off. Leave the ma-
chine off.
❒ When you make masters continuously using originals with solid images,
“SC-03-03” tends to appear on the panel display. In this case, turn off the main
switch and wait for a while. Then turn on the main switch.
Print image is larger
than the selected paper
size.
Change the paper size.
The master image previously printed is larger than the paper, the
image exceeds the paper size.
Make prints again after pressing the [Exit] key and selecting the pa-
per size again.
Note
❒ If you press the [Exit] key to erase the message and press the
{
{{
{Print}
}}
} key, the machine starts to make the prints. However, the
image might not fit on the paper.
Message Meaning