Filter
Top Products
USER TOOLS
142
3
15 Deflector Angle You can change the angle of the wing guide depending on
the paper type you use.
Note
❒
Default: Auto
❒
Available settings:
• Up (Select this setting when standard thickness or
thin paper misfeeds at the paper exit section occur
frequently.)
• Down (Select this setting when A4 – B5, 8
1
/
2
"
×
11"
thick paper is not delivered properly to the paper de-
livery tray.)
16 Manual Class When you do not use the Job Separation function, you can
select the machine's condition after each printing set is fed
out to the paper delivery tray.
Note
❒
Default: Stop
❒
Available settings:
• Start printing automatically (After the last page of
each printing set is fed out to the paper delivery tray,
the machine stops for a few seconds. Then, the next
cycle begins.)
• Stop (After the last page of each printing set is fed out
to the paper delivery tray, the machine stops. If you
press the
{
Print
}
key, the next cycle begins.)
17 Auto Separate Specifies whether Job Separation mode is automatically
carried out when you make prints in All Class, Auto Class,
Manual Class, or Class mode.
Note
❒
Default: ON
No. Mode Description