Filter
Top Products
DC and Switching Characteristics
54 www.xilinx.com DS610-3 (v2.0) July 16, 2007
Product Specification
R
Byte Peripheral Interface (BPI) Configuration Timing
Figure 14:
Waveforms for Byte-wide Peripheral Interface (BPI) Configuration
Table 53:
Timing for Byte-wide Peripheral Interface (BPI) Configuration Mode
Symbol Description Minimum Maximum Units
T
CCLK1
Initial CCLK clock period (see Table 45)
T
CCLK
n
CCLK clock period after FPGA loads ConfigRate setting (see Table 45)
T
MINIT
Setup time on M[2:0] mode pins before the rising edge of INIT_B 50 -ns
T
INITM
Hold time on M[2:0] mode pins after the rising edge of INIT_B 0 -ns
T
INITADDR
Minimum period of initial A[25:0] address cycle; LDC[2:0] and HDC are asserted
and valid
55T
CCLK1
cycles
T
CCO
Address A[25:0] outputs valid after CCLK falling edge See Table 49
T
DCC
Setup time on D[7:0] data inputs before CCLK falling edge See Table 50
T
CCD
Hold time on D[7:0] data inputs after CCLK falling edge 0 -ns
(Input)
PUDC_B must be stable before INIT_B goes High and constant throughout the configuration process.
Data DataData
AddressAddress
Data
Address
Byte 0
000_0000
INIT_B
<0:1:0>
M[2:0]
T
MINIT
T
INITM
LDC[2:0]
HDC
CSO_B
Byte 1
000_0001
CCLK
A[25:0]
D[7:0]
T
DCC
T
CCD
T
AVQV
T
CCLK1
(Input)
T
INITADDR
T
CCLKn
T
CCLK1
T
CCO
PUDC_B
New ConfigRate active
Pin initially pulled High by internal pull-up resistor if PUDC_B input is Low.
Pin initially high-impedance (Hi-Z) if PUDC_B input is High.
Mode input pins M[2:0] are sampled when INIT_B goes High. After this point,
input values do not matter until DONE goes High, at which point the mode pins
become user-I/O pins.
(Input)
PROG_B
(Input)
DS529-3_05_112906
(Open-Drain)
Shaded values indicate specifications on attached parallel NOR Flash PROM.