Filter
Top Products
Disassembly, Reassembly and Lubrication
3-29 CL-S6621
Notes on reassembling:
• When the “SA, Main PCB” is replaced with new one, perform the sensor adjustment.
Refer to
“
3-7-1 Transparent/Reflective Sensor Position Adjustment.
• When running the “Cable, Opepane”, pass it inner side of the case arms “A”. Also, after running
the “Cable, Opepane”, stick it to the case frame at point “B” with a double-faced tape.
• When connecting the flexible cable, be sure that the insertion direction is correct. If you insert it
reversely, circuit is not electrically connected.
• For the “Cable, Opepane” connected to the connector (J4), face its foil side to the rear of the
printer.
• For the cable (J9), face up its foil side.
A
Cable, Opepane
J4
B
J12
(J10)
(J13)
J5
J3
J7
J6
J4
J19
(J14)
J8
J9
J11
To SA, Opepane PCB
To SA TRA Sen PCB
(Foil side)
J9
J4
(Foil
side)
(Blue tape
side)
(Blue tape side)