Filter
Top Products
b. Click <OK>.
The target server is released from maintenance mode.
Note
If the target VM host is in a high-availability configuration, all VM guests stored on shared disks should be migrated to another VM host
beforehand.
During restore, because the target VM host will be automatically set to VM maintenance mode, the VM host should be in a state that
allows VM maintenance mode to be set.
After restoring the VM host, migrate the VM guests back to their original VM host.
Refer to the server virtualization software manual and "D.3 Functional Differences between Products" in the "Design Guide VE" for
information on how to migrate VM guests, and about the VM maintenance mode.
Even when the restore operation is canceled, the target server cannot be returned to its previous status after the image is deployed.
When the managed server has the following configuration, it may not be possible to perform backup correctly unless the following
command is executed before performing backup.
- In a SAN data environment using a built-in disk boot, and a physical WWN or VIOM
[Windows Manager]
>
Installation_folder
\SVROR\Manager\bin\rcxadm server set -name
physical server
-attr bootagt=dos <RETURN>
[Linux Manager]
#/opt/FJSVrcvmr/bin/rcxadm server set -name
physical server
-attr bootagt=dos <RETURN>
- When using the Red Hat Enterprise Linux 6 ext4 file system, and one of the following conditions is met
- In a SAN boot environment using HBA address rename
- When using a rack mount or tower server and the server is registered with "Disable" of "Association with server management
software (ServerView)" is selected
[Windows Manager]
>
Installation_folder
\SVROR\Manager\bin\rcxadm server set -name
physical server
-attr bootagt=winpe <RETURN>
[Linux Manager]
#/opt/FJSVrcvmr/bin/rcxadm server set -name
physical server
-attr bootagt=winpe <RETURN>
- In a SAN boot environment using HBA address rename, and the following model or OS
- PRIMERGY BX960 S1
- XenServer6 or later
[Windows Manager]
>
Installation_folder
\SVROR\Manager\bin\rcxadm server set -name
physical server
-attr bootagt=winpe <RETURN>
[Linux Manager]
#/opt/FJSVrcvmr/bin/rcxadm server set -name
physical server
-attr bootagt=winpe <RETURN>
- 120 -