Filter
Top Products
Note
For servers other than those using I/O virtualization and those with WWN settings registered, the following checks will not be enabled.
- [Power off forced when the server is switched over] checkbox
- [Switchover to server where VM guest exists] checkbox
[VM Host]
The automatic startup of VM guests after the switchover of their VM host depends on their virtual machines' startup configuration within
the server virtualization software used.
For details, refer to the manual of server virtualization software.
Depending on the server virtualization product used, a newly created VM guest may require some re-configuration before running a server
switchover.
Refer to "D.2 Configuration Requirements" in the "Design Guide VE" for details on such settings.
18.3 Changing Server Switchover Settings
The procedure used to change server switchover settings is the same as that described in "18.2 Settings for Server Switchover".
For details, refer to "Chapter 18 Server Switchover Settings".
18.4 Canceling Server Switchover Settings
Use the following procedure to cancel server switchover settings.
1. In the ROR console server resource tree, right-click a server (or a physical OS or VM host on the server) and select [Modify]-[Spare
Server Settings] from the popup menu.
The [Spare Server Settings] dialog is displayed.
2. Clear the checkbox in the [Select] column for the desired spare server.
3. Click <OK>.
The selected spare server is no longer set as a spare server.
- 147 -