Filter
Top Products
- PY CB Eth Switch/IBP 10Gb 18/8
- BX600 GbE Switch Blade 30/12
- PRIMERGY BX600 GbE Switch 16/2x10Gb
- PRIMERGY BX600 GbE Switch 16x1Gb
- Cisco Catalyst Blade Switch 3040
connection_type
Enter the connection method to use for the LAN switch blade.
If you configure "ssh" for a LAN switch blade which does not support SSH, or specify a character string other than ssh, the
configuration is regarded as "telnet".
- For telnet
"telnet"
- For SSH
"ssh"
VLAN Data for LAN Switch Blades
- Section Name
Enter [LanSwitchNet] as the section name.
- Section Header
operation
Enter the desired operation for the current line. Enter a hyphen ("-") to skip this line.
chassis_name
Enter the chassis name (the value of "chassis_name" in the [Chassis] section).
port_no
Enter the port number of an external LAN switch blade port. Enter numeric characters. The port number that can be specified is
different depending on the model type.
For details, refer to the manual of the LAN switch blade to be used.
vlan_id (optional)
Enter the VLAN ID and tag type ("/T" for tagged or "/U" for untagged) to be assigned to the specified LAN switch blade port.
Enter a VLAN ID followed by tag types. To specify multiple VLAN IDs, separate each set of VLAN settings using semicolons
(";"). Both tagged ("/T") and untagged ("/U") VLAN IDs can be used together, but only one untagged ("/U") type is allowed.
Example
10/U
10/U;20/T;30/T
10/T;20/T
Note
If a hyphen ("-") is entered, VLAN settings will not be performed.
This section will be ignored for PRIMERGY BX900/BX400 LAN switch blades operating in IBP mode.
- 196 -