Filter
Top Products
- LAN switch blade PY CB Eth Switch/IBP 1Gb 18/6 (3.12 or later version)
7.3.4 Configuring VLANs on LAN Switches
On managed LAN switch blades, VLANs should be set on both internal ports (those connected to network interfaces on managed servers)
and external ports (those connected to external, adjacent LAN switches).
Note
VLANs cannot be configured on PRIMERGY BX 900 and BX 400 LAN switch blades operating in IBP mode.
7.3.5 Configuring VLANs on External Ports
Use the following procedure to configure VLANs on a LAN switch blade's external ports.
1. In the ROR console server resource tree, right-click the target LAN switch blade and select [Modify]-[Network Settings] from the
popup menu.
The [VLAN Settings] dialog is displayed.
2. To use this feature, the following settings must first be defined:
VLAN
Specify the VLAN ID to assign to a LAN switch blade port.
Adding a new VLAN ID
a. Under VLAN, select [Create new].
b. Enter a VLAN ID number.
For details on VLAN IDs, refer to the manual of the LAN switch blade to be used.
Modifying an existing VLAN ID
a. Under VLAN, select [Change].
b. Select a VLAN ID.
Physical Port, Link Aggregation
Select port numbers to configure or VLAN types of link aggregation group names ([Untagged] or [Tagged]).
3. Click <OK>.
Check that the VLAN has been set.
4. Select the LAN switch blade in the server resource tree of the ROR console and display the [Resource Details] tab.
Confirm that the VLAN information is displayed in [VLAN Area] on [Resource Details].
7.3.6 Configuring VLANs on Internal Ports
Use the following procedure to configure VLANs on a LAN switch blade's internal ports.
1. In the ROR console server resource tree, right-click the target server (or the physical OS or VM host on the server), and select
[Modify]-[Network Settings] from the popup menu.
The [Network Settings] dialog is displayed.
2. Select the index of the network interface for which to assign a VLAN ID, and click <Setting>.
The [VLAN Configuration] dialog is displayed.
- 33 -