Filter
Top Products
1. From the ROR console menu, select [Settings]-[Admin LAN Subnet].
The [Admin LAN Subnet] dialog is displayed.
2. Select the subnet to change.
The [Change Admin LAN Subnet] dialog is displayed.
3. In the [Change Admin LAN Subnet] dialog, set the following items.
Subnet name
The name must start with an alphabetic character and can be up to 16 alphanumeric characters long (including underscores, "_",
hyphens, "-", and periods, ".").
Network address
Enter valid values for the network address.
Subnet mask
Enter valid values for the subnet mask.
Gateway
Enter the settings for the gateway used for communication with the admin server on the admin LAN.
4. Click <Change>.
5. Click <OK>.
Note
When changing the information for a subnet other than the one the admin server belongs to, if there is even 1 managed server belonging
to the target subnet, the "Network address" and "Subnet mask" cannot be changed.
When changing the "Network address" or "Subnet mask", refer to the "Modification Procedure when there are Managed Servers Belonging
to Different Subnets".
Modification Procedure when there are Managed Servers Belonging to Different Subnets
When there are managed servers in the target subnet, change the network address or the subnet mask using the following procedure.
1. Register the subnet information using the new network address or subnet mask.
2. Use the following procedure to change the admin LAN IP addresses of all managed servers belonging to the subnet before
modification.
For details on how to configure these settings, refer to "9.1.3 Changing Admin IP Addresses".
3. Delete the subnet used before modification.
9.1.12 Changing WWN Settings for ETERNUS SF Storage Cruiser Integration
This section explains how to change WWN settings for integration with ETERNUS SF Storage Cruiser.
The WWN settings for ETERNUS SF Storage Cruiser integration can be changed by re-configuring them.
Refer to "10.1 Configuring WWN Settings for ETERNUS SF Storage Cruiser Integration" for details on how to configure these settings.
9.2 Changing Settings for the HBA address rename Setup Service
This section explains how to change settings for the HBA address rename setup service. Such settings include the admin server IP address,
the port used to communicate with the admin server, and the IP address of the HBA address rename server.
9.2.1 Changing the IP Address of the Admin Server
This section explains how to change the IP address of the admin server.
- 72 -