Filter
Top Products
Installing a Microprocessor
9. Remove the microprocessor from the static-protective bag,
without touching or bending the pins. Place it pin-side down
on a grounded, static-protective or conductive-foam surface.
10. Open the thermal grease packet. Place the contents of the
packet on top of the microprocessor.
11. Spread the grease evenly over the surface of the microprocessor.
Ensure that the grease does not extend beyond the
microprocessor edges.
12. Discard the empty thermal grease packet.
13. Align the heat sink above the microprocessor.
14. Place the flat side of the heat sink on the layer of grease that
covers the microprocessor.
Note: When you move the microprocessor/heat sink assembly
to the socket on the processor board, hold the assembly
by the sides.
15. Center the microprocessor/heat sink assembly over the socket.
16. Carefully lower the microprocessor/heat sink assembly into the
socket. Ensure that the pins on the microprocessor/heat sink
assembly align with the holes in the socket. Do not bend the
pins.
Note: Do not force the pins into the socket. If you feel any
resistance, remove the microprocessor/heat sink assembly
and check the orientation and alignment.
Chapter 4. Installing Options 93