Filter
Top Products
Starting the Test Programs
IntruderAlert
Each time you start the diagnostic programs, IntruderAlert checks
for damage to the Diagnostic Diskette. If a virus or program
alteration is detected, the diagnostic programs will not load.
To suspend IntruderAlert and continue loading the diagnostic
programs, press Esc.
Starting the Test Programs
To start the test programs from diskette:
Note: Use your backup copy of the Diagnostic Diskette to run the
diagnostic programs.
1. Insert the backup copy of the Diagnostic Diskette into the
primary diskette drive (usually drive A).
2. Turn on the system. The IBM PC Server 704 logo appears on
your screen, followed by the system running POST. When
POST completes, QAPlus/PRO for IBM appears on your screen.
3. Press any key to continue. The Welcome window appears.
4. Press any key to continue.
Note: IntruderAlert starts and runs automatically after you
press any key. If IntruderAlert detects a problem with
the diagnostic diskette, it will automatically stop further
testing. See “IntruderAlert” for more information.
5. Press Enter.
Several analysis programs start and run automatically. When
they complete, the Main Menu appears.
6. Use the Up Arrow (↑) or Down Arrow (↓) key to move the
highlight bar to your desired Main Menu selection.
7. Press Enter.
Note: To stop running a specific test or stop testing after you
have started a test, press Esc while the test is running.
The test pauses at the first possible opportunity, and the
Skip/Abort Test Menu appears.
Chapter 5. Solving Problems 225