Filter
Top Products
Removing Memory-Module Kits
9. Reinstall the board-support panel:
a. Align the support panel so that the three tabs 1 at the
back left edge of the panel fit into the three chassis slots.
b. Close the panel. Check to make sure that the boards in the
slots behind the panel align with the scribe marks on the
panel. Use the scribe marks at 2 to check the alignment of
the memory board. Use the scribe marks at 3 to check the
alignment of the processor boards.
2
3
1
c. Secure the panel with the four screws that you removed in
step 1b on page 124.
d. Reinstall the exterior side panel.
10. Reinstall the covers (see “Completing the Installation” on
page 201) and go to Chapter 3, “Configuring Your Server” on
page 39 to reconfigure your server; then, return here and
continue with “What to do next?” on page 130 to determine
your next step.
The next time that you start the server, a message appears to
indicate that memory has been added or removed.
Chapter 4. Installing Options 129