IBM 704 Server User Manual


 
Checking for Damage
Checking the System for Damage
This section provides instructions on what to do if your system is
damaged.
After Dropping It
Obvious damage:
Look for loose cables and obvious damage. If any cables are loose,
reconnect them securely. If there is obvious damage to the system,
have it serviced.
No obvious damage:
If you see no damage, turn on the system. If it works correctly, the
system probably did not suffer any damage.
Note: To avoid personal injury or damage to your system, observe
all safety and electrostatic precautions listed in “Safety
Information” on page v and the PC Server 704 Safety
Information booklet.
If it does not work correctly, turn off the system and check the
adapters and memory modules to ensure that they are seated
correctly. See Chapter 4, “Installing Options” on page 73 and
follow the instructions for opening your system; then, reseat all
adapters and memory modules.
If the system still does not work correctly, start the test programs
and test the system. See “Starting the Test Programs” on page 225
for instructions.
Chapter 5. Solving Problems 261