Filter
Top Products
Windows NT Server 3.51 Installation
For installation instructions for Windows NT Server 3.51, refer to the
README file on the diskette that comes with your operating
system.
In addition, you must do the following steps:
1. Run the System Configuration Utility program as described in
“Starting the System Configuration Utility Program” on
page 47.
2. Select Step 3: Change Configuration Settings from the menu.
3. Select System Board.
4. Select MP Spec.
5. Verify that the MP Spec version is 1.4. If the version number is
different, change it to 1.4.
6. If your server did not come with ServerGuide, or if you chose
not to use ServerGuide to install your operating system,
continue with the next step. Otherwise, skip the remaining
steps and go to “Device Drivers” on page 36; then, go to
“Installation Checklist” on page 37.
7. Format every hard disk drive that is installed in the server:
a. If your server came with a RAID adapter installed, review
your RAID adapter documentation to obtain the appropriate
FORMAT command for your server. Run the RAID adapter
utility program to format the hard disk drives.
b. If your server did not come with a RAID adapter installed,
review your SCSI Software User's Guide to obtain the
appropriate FORMAT command for your server. Run the
Adaptec utility program to format the hard disk drives.
8. Start a DOS diskette.
9. Use a DOS FDISK command to create an installation partition.
The recommended size is less than 500 MB.
10. Modify the first installation diskette with NTKRNLMP.EXE from
Microsoft Service Pack #3.
34 PC Server 704 User's Handbook