Filter
Top Products
Installing Memory-Module Kits
5. Touch the static-protective package to any unpainted metal
surface on the server. Then, remove the memory-module kit
from the package.
Static
Devices
6. Install the kit:
a. Start with the lowest-numbered sockets in bank 1.
b. Turn the memory module so that the notched end 1 is on
the left, and the top faces away from you.
c. Insert the SIMM into the memory-board connector,
downward at a 45-degree angle.
d. Press the SIMM firmly into the socket 2, until it is grasped
by the retaining clips 3. Verify that the SIMM has been
installed correctly. If the SIMM remains at an angle, it has
been installed correctly. If a gap exists between the SIMM
and the clips, the SIMM has not been properly installed. In
this case, open the clips and remove the SIMM; then,
reinsert the SIMM.
1
2
3
Chapter 4. Installing Options 119