Filter
Top Products
The following lists the parameters which may be used with the tcmerge command.
Parameter Description
<file1|directory1> First file or directory to merge. A combination of filenames and
directory names is not valid.
<file2|directory2> Second file or directory to merge.
[<file3|directory3>] Third file or directory to merge. (Optional)
[-ti[tles] <titlenames>] Names of files or directories being merged.
[-out <file|directory>] The file or directory into which the merged differences will be
written. This flag is optional.
[-prime[out] <file|directory>] Primes the specified input file or directory to the output
window.
[-re[place]] The filename with the -out flag will be replaced. If not specified,
and the filename specified with the -out flag exists, the
-replace flag must be specified.
[-ignoreco[lumns] <list of
ranges to ignore>]
List of column ranges to ignore during the compare. Entries
must use the format <startColumn,endColumn> with no blanks
within an entry. Specify one column <Column> where start and
end would be the same number.
[-ignoreb[lanks] <l|t|a|lt>] Specifies blanks to ignore. Specify one: l (leading), t (trailing),
lt (leading trailing), or a (all blanks). Specify: l for blanks at the
beginning of a line; t for blanks at the end of a line; lt for
blanks at the beginning and end of the line; a for all blanks on
a line.
[-ignoreca[se]] Case of the characters is ignored. For example, there is no
difference when an uppercase ″C″ and a lowercase ″c″ are
compared.
[-ignoreb[lanklines]] Any blank lines are ignored during the compare.
[-ignoreu[nique]
<file|directory>]
An input file or directory is ignored during the compare.
[-auto[merge]] Automatically merge differences between files or directories.
When conflicts found, a GUI is invoked for you to resolve the
conflict. Use this with the -out parameter to keep input source
files unchanged.
Note: Using this parameter is equivalent to using the
TeamConnection automrg command. See the Commands
Reference for additional information.
[-nologo] Hides the TeamConnection logo.
240 User’s Guide