Filter
Top Products
to make some modifications to the parts in this release. This fix will require the tasks
noted in the following table:
For information about this task, Go to this
page.
Accepting the defect 52
Creating a work area 53
Checking out a part 54
Searching for a part 55
Checking in a part 58
Verifying and testing part updates 60
Freezing the work area 65
Refreshing the work area 66
Building the application 67
Integrating the work area 68
Closing the defect 69
Accepting a defect
Alex is notified via electronic mail that defect 310 has been opened against the robot
component. After some research, he agrees that there is a problem with the aperture of
the robot’s on-board camera, so he accepts the defect. Alex does one of the following:
GUI
From the GUI, he:
1. Selects Defects → Accept from the Actions pull-down menu on the Tasks window.
The Accept Defects window appears.
Note: The Accept Defects window in this example may be different than one you
may see based on your environment. Configurable fields may or may not be
shown depending on any configurable fields set by you or your administrator,
2. Types 310 in the Defects field and selects program_defect from the Answer list.
3. Selects OK.
52 User’s Guide