• Connecting Earth Ground to an EX Series Switch on page 141
Mounting an EX3200 or EX4200 Switch on a Desk or Other Level Surface
You can mount an EX3200 or EX4200 switch on a desk or other level surface by using
the 4 rubber feet that are shipped with the switch. The rubber feet stabilize the chassis.
Before mounting an EX3200 or EX4200 switch on a desk or other level surface:
•
Verify that the site meets the requirements described in “Site Preparation Checklist
for EX3200 and EX4200 Switches” on page 87.
•
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
•
Read “General Safety Guidelines and Warnings for EX Series Switches” on page 207,
with particular attention to “Chassis Lifting Guidelines for EX3200 and EX4200
Switches” on page 220.
•
Remove the switch from the shipping carton (see “Unpacking an EX3200 or EX4200
Switch” on page 118).
Ensure that you have the following parts and tools available:
•
4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in
the accessory box shipped with the switch)
•
Dust covers for ports (for EX4200-24F switches only; optional)
To mount the switch on a desk or other level surface:
1. Turnthe chassis upside down on the desk or the level surface where you intend to
mount the switch.
2. Attachtherubberfeettothebottomofthechassis,asshowninFigure37onpage121.
3. Turn the chassis right side up on the desk or the level surface.
4. If it is an EX4200-24F switch, we recommend you insert dust covers in unused SFP
ports.
Figure37:AttachingRubberFeettoanEX3200orEX4200 SwitchChassis
121Copyright©2010, JuniperNetworks, Inc.
Chapter9:Installing theSwitch