Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-31
Removal and Replacement Procedures
RRP 9.13 Feed Roll Assembly (PL3.1.1)
Removal
1. Remove Tray 1 from the printer.
2. Remove the Rear Cover (RRP 9.4)
3. Remove the Main Paper Handling Assembly (RRP 9.36).
4. Remove the two screws securing the Turn Chute to the printer frame and remove the Turn Chute.
5. Remove the two screws securing the Option Plug/Jack Bracket to the rear of the printer frame and pull
the Bracket away from the frame so you can access the Feed Gear.
6. Remove the Feed Spring from the Feed Gear.
7. Remove the E ring securing the Feed Gear to the Feed Shaft and remove the Gear.
8. Remove the screw securing the Feed Shaft Guide to the front of the frame and remove the Guide.
9. Remove the Front Feed Roll (RRP 9.14).
10. Rotate the Feed Shaft so the Rear Feed Roll clears the No Paper Bracket and slide the rear of the
Shaft out of the rear bearing.
11. Slide the front of the Shaft out of the front bearing and remove the Shaft.
Replacement
1. Remove the Front Feed Roll from the Feed Shaft (RRP 9.14).
2. Slide the front bearing onto the end of the Feed Shaft.
3. Slide the front of the Shaft through the cutout in the front of the frame.
4. Push the Shaft far enough through the cutout so you can insert the rear bearing, attached to the rear of
the Shaft, into the cutout in the rear of the frame.
5. Slide the front bearing along the front of the Shaft and insert it into the cutout in the front of the frame.
6. Reinstall the Feed Shaft Guide onto the printer frame and over the front end of the Feed Shaft, and
use one screw to secure the Guide.
7. Reinstall the Front Feed Roll (RRP 9.14).
8. Rotate the Shaft so the Feed Rolls are up.
9. Hold the Feed Shaft in position and push down on the Feed Solenoid arm as you slide the Feed Gear
onto the rear of the Shaft.
10. Use and E ring to secure the Feed Gear to the Shaft.
11. Reinstall the Feed Spring, with one end attached to the frame and the other attached to the tab on the
Feed Gear.
12. Reinstall the Option Plug/Jack Bracket onto the rear of the printer frame.
13. Use two screws to secure the Option Plug/Jack Bracket to the frame.
14. Reinstall the Turn Chute onto the printer frame, making sure you slide the bottom of the Chute under
the Turn Roll Assembly so the four Turn Rolls fit through the opens in the Chute.
15. Use two screws to secure the Turn Chute to the printer frame.
16. Reinstall the Main Paper Handling Assembly (RRP 9.36).
17. Reinstall the Rear Cover (RRP 9.4).
18. Reinstall Tray 1 into the printer.