Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-139
Removal and Replacement Procedures
RRP 9.67 Rotary Frame Assembly (PL7.2.2)
Removal
1. Remove the Yellow Developer Assembly (RRP 9.59).
2. Remove the Magenta Developer Assembly (RRP 9.61).
3. Remove the Cyan Developer Assembly (RRP 9.63).
4. Remove the Black Developer Assembly (RRP 9.65).
5. If present, remove the screw securing the Rotary Knob the Rotary Shaft.
6. Release the Knob latch by inserting a screwdriver blade through the slot in the front of the Knob and
pull the off of the Shaft (Figure 1).
7. Remove the Rotary Motor Assembly (RRP 9.114).
8. Remove the Dispense Motor Assembly (RRP 9.116).
9. Remove the Developer Clutch Assembly (RRP 9.117).
10. Remove the Developer Tie Plate (RRP 9.118).
11. Remove the Rotary Sensor (RRP 9.68).
12. Remove the large E ring securing the Rear Rotary Bearing to the rear of the printer frame and slide the
Rear Bearing off of the Rotary Frame shaft (Figure 2).
13. Slide the Front Rotary Bearing off of the Rotary Frame shaft.
14. Slide the Rotary Frame Assembly to the front of the printer frame.
15. Pull the rear of the Rotary Frame Assembly free of the rear frame, swing the rear of the Assembly out
of the printer and remove the Assembly.
Replacement
1. Insert the Rotary Frame Assembly front shaft through the cutout in the front of the printer frame.
2. Swing the rear of the Rotary Frame Assembly into the printer and insert the Assembly rear shaft into
the cutout in the rear of the printer frame.
3. Slide the Front Rotary Bearing, lip of Bearing facing out, onto the Rotary Frame shaft and into the cut-
out in the front of the printer frame.
4. Slide the Rear Rotary Bearing, lip of Bearing facing out, onto the Rotary Frame shaft and into the cut-
out in the rear of the printer frame.
5. Use a large E ring to secure the Rotary Frame shaft to the Rear Rotary Bearing to the frame.
6. Reinstall the Rotary Sensor (RRP 9.68).
7. Reinstall the Developer Tie Plate (RRP 9.118).
8. Reinstall the Developer Clutch Assembly (RRP 9.117).
9. Reinstall the Dispense Motor Assembly (RRP 9.116).
10. Reinstall the Rotary Motor Assembly (RRP 9.114).
11. Reinstall the Rotary Knob.
12. Reinstall the Black Developer Assembly (RRP 9.65).
13. Reinstall the Cyan Developer Assembly (RRP 9.63).
14. Reinstall the Magenta Developer Assembly (RRP 9.61).
15. Reinstall the Yellow Developer Assembly (RRP 9.59).