Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-35
Removal and Replacement Procedures
RRP 9.15 Feed Solenoid (PL3.1.9)
Removal
1. Remove the Rear Cover (RRP 9.4)
2. Remove the two screws securing the Turn Chute to the printer frame and remove the Turn Chute.
3. Remove the two screws securing the Option Plug/Jack Bracket to the rear of the printer frame and pull
the Bracket away from the frame so you can access the Feed Solenoid (Figure 1).
4. Disconnect P/J 103.
5. Remove the screw securing the Feed Solenoid to the printer frame (Figure 2).
6. Push down on the Solenoid arm so the Solenoid can clear the Feed Gear and remove the Solenoid
from the printer frame.
Replacement
1. Push down on the Feed Solenoid arm so the Solenoid can clear the Feed Gear and reinstall the Sole-
noid onto the printer frame.
2. Use one screw to secure the Solenoid to the printer frame.
3. Reconnect P/J 103.
4. Reinstall the Option Plug/Jack Bracket onto the rear of the printer frame.
5. Use two screws to secure the Option Plug/Jack Bracket to the frame.
6. Reinstall the Turn Chute onto the printer frame, making sure you slide the bottom of the Chute under
the Turn Roll Assembly so the four Turn Rolls fit through the opens in the Chute.
7. Use two screws to secure the Turn Chute to the printer frame.
8. Reinstall the Rear Cover (RRP 9.4).