Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-205
Removal and Replacement Procedures
RRP 9.100 Exit Tray (PL10.1.10)
Removal
1. Collapse the Exit Tray extensions.
2. Close the Exit Tray.
3. Remove the front pivot arm of the Tray from the front pivot hole in the printer frame.
4. Remove the rear pivot arm of the Tray from the rear pivot hole in the printer frame and remove the Exit
Tray.
Replacement
1. Insert the rear pivot arm of the Tray into the rear pivot hole in the printer frame.
2. Pull down on the leaf spring that is located on the front pivot arm and insert the front arm into the front
pivot hole, making sure the spring rests against the printer frame and is not inside the pivot hole.
3. Open and close the Exit Tray to make sure it moves smoothly.