Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-215
Removal and Replacement Procedures
RRP 9.105 Exit-3 Roll Assembly (PL10.2.7)
Removal
1. Remove the Top Cover (RRP 9.3).
2. Open the Lower Exit Assembly.
3. Remove the E ring securing the Spur Gear to the front of the Exit-3 Roll Shaft and remove the Gear.
4. Remove the E ring securing the Exit-3 Roll Shaft to the rear of the Lower Exit Assembly.
5. Slide the Front and Rear Bearings off of the Exit-3 Roll Shaft.
6. Remove the Exit-3 Roll Assembly from the Lower Exit Assembly.
Replacement
1. Position the Exit-3 Roll Assembly so the four rubber rollers line up with the indentations in the Lower
Exit Assembly.
2. Reinstall the Exit-3 Roll Assembly into the slot in the Lower Exit Assembly.
3. Slide the Front and Rear Bearings onto the Exit-3 Roll Shaft and push the Bearings into the notches in
the Lower Exit Assembly.
4. Slide a Spur Gear onto the front of the Exit-3 Roll Shaft and use an E ring to secure the Gear to the
Shaft.
5. Use an E ring to secure the Exit-3 Roll Shaft to the front of the Lower Exit Assembly.
6. Reinstall the Top Cover (RRP 9.3).