Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-187
Removal and Replacement Procedures
RRP 9.91 Exchange Chute (PL9.3.10)
Removal
1. Remove the Main Fuser Assembly (RRP 9.81).
2. Place the Fuser Tray on a flat and stable work surface.
3. Remove the screw securing the Exchange Stopper-R to the Tray and remove the Stopper.
4. Pull the rear of the Exchange Chute free from the Exchange Solenoid.
5. Remove the screw securing the Exchange Stopper-F to the Tray and remove the Stopper.
6. Pull the front of the Exchange Chute, along with the Exchange Spring, free from the notch in the front
of the Fuser Tray and remove the Exchange Chute.
Replacement
1. Insert the front of the Exchange Chute, the straight end, into the notch in the front of the Fuser Tray.
2. Insert the rear of the Exchange Chute, the forked end, into the notch in the rear of the Fuser Tray, mak-
ing sure the fork engages the Exchange Solenoid plunger.
3. Reinstall the Exchange Spring onto the front end of the Exchange Chute, making sure the straight end
of the Spring rests on top of the Chute arm and the hooked end of the Spring is captured by the tab
extending from the Fuser Tray.
4. Reinstall the Exchange Stopper-F to the Tray and use one screw to secure the Stopper.
5. Reinstall the Exchange Stopper-R to the Tray and use one screw to secure the Stopper.
6. Reinstall the Main Fuser Assembly (RRP 9.81).