Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-189
Removal and Replacement Procedures
RRP 9.92 Exchange Solenoid (PL9.3.16)
Removal
1. Remove the Oil Cam Solenoid (RRP 9.93).
2. Remove the Exchange Chute (RRP 9.91).
3. Remove the screw securing the Exchange Bracket to the Fuser Tray and slide the Exchange Bracket
out of the Tray (Figure 1).
4. Remove the two screws securing the Exchange Solenoid to the Exchange Bracket and remove the
Solenoid (Figure 2).
Replacement
1. Reinstall the Exchange Solenoid onto the Exchange Bracket.
2. Line up the two screw holes in the Solenoid with the two screw holes in the Bracket.
3. Use two screws to secure the Solenoid to the Bracket.
4. Line up the positioning tab on the Fuser Tray with the positioning hole in the Exchange Bracket and
reinstall the Bracket the Tray.
5. Reposition the Bracket as necessary to make sure the Oil Cam Assembly shaft fits through the hole in
the Bracket and the Idler Gear shaft fits into the hole in the Fuser Tray.
6. Use two screws to secure the Exchange Bracket to the Fuser Tray.
7. Reinstall the Exchange Chute (RRP 9.91).
8. Reinstall the Oil Cam Solenoid (RRP 9.93).