Filter
Top Products
5-2 magicolor 330 - Base Engine Service Manual
Primary Fault Isolation Procedures
5-Image Quality FIPs
Before entering the Image Quality FIPs:
1. Does the printer display an error message? If so, go to Section 2 FIP Flowchart and start troubleshooting
there.
2. Is the AC power provided at the wall outlet within recommended specifications?
3. Is the printer properly grounded through the AC wall outlet?
4. Is the printer located in an area where the temperature and humidity are moderate and stable?
5. Is the printer located in an area that is free of dust?
6. Is the printer located in an area away from water outlets, steamers, electric heaters, volatile gases, or open
flames?
7. Is the printer shielded from the direct rays of the sun?
8. Does the printer have recommended space around all sides for proper ventilation?
9. Is the printer on a level and stable surface?
10. Is recommended paper stock being used in the printer?
11. Does the customer use the printer as instructed in the User Manual?
12. Have consumables been replaced at the recommended intervals?
13. Do you have access to QMS Engine Diagnostic menus and do you know how to use them?
14. Are all of the printer assemblies in place and are all of printer covers and doors firmly closed?