Filter
Top Products
magicolor 330 - Base Engine Service Manual 3-13
Primary FIPS: Error Messages
3.10 - Error Message: Put <Size> Paper in OPT1 Bin
OPT1 tray is out of paper.
Logic control on the MCU PWB detected that the No Paper Sensor in Tray 2 is actuated. The Engine Diagnostic
Menu may refer to the the OPT1 Bin no paper sensor as Tray 2 no paper sensor..
Step Actions and Questions Yes No
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the LCIF with the MCU PWB
1
LCIF TRAY INSPECTION
Slide OPT1 tray out of the LCIF.
Is the Tray out of paper?
Load paper
into the Tray.
Go to step 2
2
NO PAPER SENSOR TEST
1. Enter Diagnostics and test OPT1/Tray 2 No Paper Sen-
sor.
2. Manually actuate and deactuate the No Paper Sensor.
Is "actuated" displayed when you manually actuate the sen-
sor? And, is "not actuated" displayed when you manually
deactuate the sensor?
Go to step 3 Replace OPT1/
Tray 2 No
Paper Sensor
Assembly
(LCIF RRP
6.23)
3
Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
Go to step 4 Problem
Solved
4
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
Go to suspect
components
Problem
Solved