Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-149
Removal and Replacement Procedures
RRP 9.72 Tension Lever (PL8.1.4)
Removal
1. Remove the Xerographic Cartridge (RRP 9.48).
2. Rotate the Tension Lever clockwise.
3. Loosen the screw securing the Tension Lever to the IBT Push In Shaft.
4. Slide the Tension Lever off of the Shaft.
Replacement
1. Rotate the Tension Lever slightly to find the flat spot on the IBT Push In Shaft, then push the Lever as
far as it will go onto the Shaft.
2. Tighten the screw securing the Tension Lever to the IBT Push In Shaft.
3. Rotate the Tension Lever counter clockwise and clockwise to make sure the Lever is securely in place
on the Shaft.
4. Reinstall the Xerographic Cartridge (RRP 9.48).