Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-33
Removal and Replacement Procedures
RRP 9.14 Feed Roll (PL3.1.3)
We recommend that you replace Feed Rolls as a set.
Removal
1. Remove Tray 1 from the printer.
2. Remove the Main Paper Handling Assembly (RRP 9.36).
3. Remove the two screws securing the Turn Chute to the printer frame and remove the Turn Chute.
4. Reach in through the empty paper feeder and spread the plastic arms of the Front Feed Roll as you lift
the Roll off of the shaft.
5. Reach in through the empty paper feeder and spread the plastic arms of the Rear Feed Roll as you lift
the Roll off of the shaft.
Replacement
1. Remove Tray 1 from the printer.
2. Remove the Main Paper Handling Assembly (RRP 9.36).
3. Remove the two screws securing the Turn Chute to the printer frame and remove the Turn Chute.
4. Position the Rear Feed Roll as shown in the figure.
5. Line up the locating pin on the Feed Roll with the hole in the shaft.
6. Reach in through the empty paper feeder and use your hand to support the shaft as you press the
Rear Feed Roll onto the shaft.
7. Position the Front Feed Roll as shown in the figure.
8. Line up the locating pin on the Feed Roll with the hole in the shaft.
9. Reach in through the empty paper feeder and use your hand to support the shaft as you press the
Front Feed Roll onto the shaft.
10. Reinstall the Turn Chute onto the printer frame, making sure you slide the bottom of the Chute under
the Turn Roll Assembly so the four Turn Rolls fit through the opens in the Chute.
11. Use two screws to secure the Turn Chute to the printer frame.
12. Reinstall the Main Paper Handling Assembly (RRP 9.36).
13. Reinstall Tray 1 into the printer.