Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-175
Removal and Replacement Procedures
RRP 9.85 Pressure Roll Heat Rod (PL9.2.19)
Removal
1. Remove the Upper Fuser Assembly (RRP 9.87).
2. Remove the shrink tubing that is covering the connectors linking the Pressure Roll Heat Rod and the
Heat Roll Heat Rod.
3. Push out on the connector latch and disconnect the two Rods from each other.
4. Free the rear of Pressure Roll Heat Rod from the Fuser Rear Cover.
5. Slide the Pressure Roll Heat Rod out of the Pressure Roll.
Replacement
Handle the Heat Rod by the ceramic end tips. If you accidently touch the glass tube, wipe
the it clean with a soft, dry cloth.
1. Carefully insert the flat end of the Heat Rod into the rear of the Pressure Roll and push the Rod until
the flat end exits the front of the Pressure Roll
2. Insert the rear of the Pressure Roll Heat Rod and the rear of the Heat Roll Heat Rod through the cut-
outs in the Rear Fuser Cover.
3. Reconnect the Pressure Roll Heat Rod to the Heat Roll Heat Rod.
4. Reinstall a new piece of shrink tubing over the connection.
5. Reinstall the Upper Fuser Assembly (RRP 9.87).