Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-93
Removal and Replacement Procedures
RRP 9.44 Rubber Registration Roll (PL5.2.24)
Removal
1. Remove the Metal Registration Roll (RRP 9.43).
2. Remove the E ring at the front of the Rubber Registration Roll securing the Gear to the Roll and
remove the Gear.
3. Remove the E ring securing the rear of the Rubber Registration Roll to the Main Paper Handling
Assembly.
4. Remove the rear bearing and Spring from the end of the Rubber Registration Roll.
5. Slide the Rubber Registration Roll out of the Main Paper Handling Assembly.
Replacement
1. Slide the front end of the Rubber Registration Roll into the front bearing in the Main Paper Handling
Assembly.
2. Hold the mylar strip out of the way as you insert the Rubber Registration Roll into the channel in the
Main Paper Handling Assembly.
3. Make sure the mylar strip rests on top of the Rubber Registration Roll.
4. Reinstall the rear bearing and Spring, facing down, onto the rear of the Roll.
5. Use an E ring to secure the rear of the Roll to the rear bearing.
6. Reinstall the Gear onto the front end of the Rubber Registration Roll and use an E ring to secure the
Gear to the Roll.
7. Reinstall the Metal Registration Roll (RRP 9.43).