Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-223
Removal and Replacement Procedures
RRP 9.109 Paper Handling Drive Assembly (PL11.1.1)
Removal
1. Remove the High Voltage Power Supply (RRP 9.120).
2. Slide the Main Paper Handling Assembly out of the printer.
3. Remove the screw securing the wire clip to the Paper Handling Drive Assembly and move the clip and
harness out of the way (Figure 1).
4. Remove the five screws securing the Paper Handling Drive Assembly to the printer frame and remove
the Assembly (Figure 2).
5. Remove the two wire clamps from the Drive Assembly.
Replacement
1. Reinstall the two wire clamps onto the Paper Handling Drive Assembly.
2. Position the Paper Handling Drive Assembly against the printer frame so the single gear fits through
the cutout at the top of the frame.
3. Press the Paper Handling Drive Assembly against the printer frame so all of the gears fit though the
cutouts and the five screw holes in the Assembly line up with the five screw holes in the frame.
4. Use five screws to secure the Paper Handling Drive Assembly to the printer frame.
5. Reinstall the wire clip and attached wire harness to the Paper Handling Drive Assembly and use one
screw to secure the clip to the Assembly.
6. Slide the Main Paper Handling Assembly into the printer.
7. Reinstall the High Voltage Power Supply (RRP 9.120).