Filter
Top Products
magicolor 330 - Base Engine Service Manual 9-261
Removal and Replacement Procedures
RRP 9.128 Controller Fan (PL14.1.2)
Removal
1. Remove the Right Cover (RRP 9.8).
2. Remove the Top Cover (RRP 9.3).
3. Disconnect the Controller Fan P/J 314 from the Controller PWB.
4. Remove the two screws securing the Controller Fan to the printer frame and remove the Fan.
Replacement
1. Position the Controller Fan with the label facing up and the wires close to the grommet hole.
1. Reinstall the Fan onto the printer frame.
2. Use two screws to secure the Fan to the printer frame.
3. Route the Fan wire through the grommet hole.
4. Reconnect the Controller Fan P/J 314 to the Controller PWB.
5. Reinstall the Top Cover (RRP 9.3).
6. Reinstall the Right Cover (RRP 9.8).