Filter
Top Products
B–Cisco Nexus 5000 Series Switch Configuration
Verify that the Adapter Is Logged into the Switch
FE0254601-00 A B-5
Verify that the Adapter Is Logged into the Switch
To verify that the switch has been properly configured and that the adapter has
logged into the switch:
1. List the devices that have logged into the switch, and compare the device
WWN with the information from the QLogic adapter port by entering the
show flogi database command. In the example, vfc 19 is logged into
the switch and visible in the switch name server database.
nexusmv1(config-if)# show flogi database
--------------------------------------------------------------------------------
INTERFACE VSAN FCID PORT NAME NODE NAME
--------------------------------------------------------------------------------
fc2/1 1 0xc60000 20:04:00:20:c2:08:57:95 10:00:00:20:c2:08:57:95
fc2/2 1 0xc60001 20:03:00:20:c2:08:57:95 10:00:00:20:c2:08:57:95
fc2/3 1 0xc60004 20:02:00:20:c2:08:57:95 10:00:00:20:c2:08:57:95
fc2/4 1 0xc60002 20:01:00:20:c2:08:57:95 10:00:00:20:c2:08:57:95
fc3/1 1 0xc60006 20:04:00:20:c2:04:50:24 10:00:00:20:c2:04:50:24
fc3/3 1 0xc60005 20:02:00:20:c2:04:50:24 10:00:00:20:c2:04:50:24
fc3/5 1 0xc60007 20:01:00:20:c2:04:50:24 10:00:00:20:c2:04:50:24
fc3/7 1 0xc60008 20:03:00:20:c2:04:50:24 10:00:00:20:c2:04:50:24
vfc19 1 0xc6001c 10:00:00:00:c9:9c:c2:ed 20:00:00:00:c9:9c:c2:ed
Total number of flogi = 9.
2. Verify the detailed properties of the virtual Fibre Channel interface.
# show interface vfc 19
3. Configure zoning on the switch, as needed. For information about zoning the
switch, refer to the Cisco switch documentation.
4. Save the current switch configuration so that the configuration is persistent
across switch reboots by issuing the following command:
# copy running-config startup-config