Filter
Top Products
C–Brocade CEE/FCoE Switch/Blade Configuration
Configure LLDP/DCBX for FCoE
FE0254601-00 A C-5
6. Verify the CEE-MAP configuration by issuing the following command:
(config)# do show cee maps
CEE Map demo
Precedence 1
Priority Group Table
1: Weight 50, PFC Enabled, TrafficClass 3, BW% 40
2: Weight 50, PFC Disabled, TrafficClass 6, BW% 60
15.0: PFC Disabled
15.1: PFC Disabled
15.2: PFC Disabled
15.3: PFC Disabled
15.4: PFC Disabled
15.5: PFC Disabled
15.6: PFC Disabled
15.7: PFC Disabled
Priority Table
CoS: 0 1 2 3 4 5 6 7
---------------------------------------------
PGID: 2 2 2 1 2 2 2 2
FCoE CoS: None
Enabled on the following interfaces
For information about associating the CEE-MAP with interfaces, refer to
“Configure CEE Port” on page C-6.
Configure LLDP/DCBX for FCoE
To configure the LLDP/DCBX for FCoE:
1. Enable LLDP by issuing the following command:
(config)# protocol lldp
2. Enable the switch to advertise the DCBX FCoE application TLV by issuing
the following command:
(config)# advertise dcbx-fcoe-app-tlv
3. Enable the switch to advertise the DCBX FCoE logical link TLV by issuing
the following command:
(config)# advertise dcbx-fcoe-logical-link-tlv