Filter
Top Products
3–Installation in a Windows Environment
Installing Software
3-14 FE0254601-00 A
12. Confirm that the QLogic 10Gb network adapter is shown in the list of
network adapters (Figure 3-12), and then click Next.
Figure 3-12. Confirming the Ethernet Adapter
13. The Microsoft Windows Hardware Update Wizard installs the NDIS driver for
the QLogic adapter NIC function.
14. When the installation is complete, click Finish to close the Hardware Update
Wizard.
Installing the FCoE Driver for Windows Server 2003
This procedure describes how to install the FCoE driver for one adapter port on a
Windows Server 2003 using Device Manager. For adapters with multiple ports,
you must repeat this procedure for each port. To install the FCoE driver:
1. Install the adapter as described in “Installing Hardware” on page 3-4.
2. After the Microsoft Windows operating system has completed booting up,
log on to the server as the Administrator.
3. Right-click on the My Computer icon on the desktop or in the Start menu,
and then select Manage.
4. In the Computer Management window, select Device Manager in the left
pane.
5. Scroll down the list of hardware types in the right pane. If you are installing
the QLogic adapter drivers for the first time on this server, do the following;
otherwise, go to Step 6:
a. Click Other Devices to see a list of devices for which a driver is not
installed on the server. Find each port of the QLogic adapter FCoE
function that is listed as Fibre Channel Controller under this section.
Figure 3-7 shows typical entries for a dual-port QLogic 8100 Series