Toshiba DK16 Network Card User Manual


 
INSTALLATION-PERIPHERALS
SECTION 100-816-207
MARCH 1993
NOTE:
DKI 6 K4RCU
The K4RClJ or QRCU allows VM DTMF dialing.
I
,
r’
VOICE MAIL OR AUTO
I 1
MDF ATTENDANT MACHINE
DK8 QSTU (CKT 1 & 2)
PSTU (CK+‘i -8)
I
DK16 PES&KT 1 & 2)
DK16 KSTUO;CKT 1 - 4)
I
I I
s
i ’
I
I
QSTU, K&J/PSTU/PESlJ ClRCUlT TIP & RING
25-P/N CABLE
(1 PAIR PER PORT)
(8 CIRCUITS PER PSTU)
(2 CIRCUITS PER PESU)
(4 ClRCUlTS PER KSTU)
(2 CIRCUITS PER QSTU)
FIGURE 7-22
DK8ANDDK16VOlCEMAIL/AUTOATTENDANTBLOCKDlAGRAM
l
B Tone Signals.
Stations send a recall (B) tone
to VP whenever Toshiba VP answers a transfer
(camp-on) recall from a station that did not an-
swer a Toshiba VP blind transfer. (The B tone
notifiesToshibaVP that the call is a recall and not
a new call, allowing Toshiba VP to respond with
the appropriate greeting.) For this feature to
operate, the QSTU, PSTU, KSTU, or PESU
voice mail ports must have LEDs 19 and 20
turned ON in
Program 31.
7.14 Toshiba VP Installation.
Use the preceding
information in concert with Paragraphs 7.23 and 7.24
to install Toshiba VP.
7.20 Customer-supplied Voice Mail Messaging
Systems
7.21
STRATA DK8 and DK16 systems are de-
signed to support a wide range of customer-sup-
plied voice mail messaging systems. Depending
on the voice mail system used, some of the features
available with ToshibaVP (refer to Paragraph 7.10)
may be available with the customer-supplied sys-
tem.
7.22 DK8 and DK16 Voice Mail (QSTU, PSTU,
KSTU, or PESU Port) Programming Consider-
ations
7.23 Voice mail (all types) QSTU, KSTU, PSTU, or
PESU port programming is accomplished using
Programs 31
and 10-2 (refer to Programming
Procedures, Section
100-816-300,
for details). Voice
mail (VM) programming features are:
l
VM
Groups-This feature groups VM QSTU,
KSTU, PSTU or PESU ports together so that
message waiting set/cancel signals appear to
originate from the lowest port in the VM group. All
VM ports connected to a particular VM machine
should be set in the sameVM group
(Program 31,
LEDs 05 - 08).
l
Message Waiting
Set/Cancel-If the VM ma-
chine has the ability to dial a code, plus the
appropriate station numbers to set or cancel the
message waiting LEDs on electronic telephones,
7-30