Filter
Top Products
103
This procedure will discuss Di-
rect Transmission when se-
lected as the default setting or
when Residual Memory has
been depleted.
Load the document face down
in the Document Tray (see
page 88).
Adjust the resolution and con-
trast if desired (see page 89).
Dial the facsimile number of the
remote party using any of the
four dialing methods.
• One Touch Key Dialing
... See page 97
• Abbreviated Dialing
... See page 98
• Alphabet Dialing
... See page 99
• Keypad Dialing
... See page 100
• Press
if a dialing er-
ror occurs.
Example of screen displayed
while a number is entered using
Keypad Dialing:
Once the facsimile number is
entered, the dialing starts.
Direct Transmission is used if
there is not enough residual
memory or when a large num-
ber of document pages are to
be sent, etc.
This mode is also useful if the
operator wishes to visually con-
firm the actual transmission of
the document to the remote par-
ty.
The documents will remain in
the ADF and be transmitted one
by one.
Direct Transmission
Load the Document
1
Dial the Facsimile
Number
2
Start Dialing
3
Example of screen displayed
when Residual Memory has
been depleted:
MAY-17-00 WED11:49
RESIDUAL MEMORY 100%
ENTER TEL NUMBER
MAY-17-00 WED11:49
RESIDUAL MEMORY 0%
ENTER TEL NUMBER
DIALING
FILE NBR = 025
0559761234
WAITING TO REDIAL
RESIDUAL MEMORY 100%
MAY-17-00 WED11:59
LINE BUSY
If the destination facsimile is
busy, the screen below is dis-
played.
If the redial procedure is com-
pleted without success, the
screen below is displayed and
this transmission job is can-
celled.
Direct Transmission as Default Setting
Connect the Line to
the Remote Party
4
Once connected to the destina-
tion facsimile, the screen below
is displayed.
COMMUNICATING
FILE NBR = 025
0559761234
COMMUNICATING
FILE NBR = 025
+81 559 761234
The remote party Terminal ID
will be displayed as shown be-
low.
COMM. RESERVATION
TEL NUMBER =(MAX128)
0559761234