Filter
Top Products
34
This section provides several
quick start programming steps
to prepare your new facsimile
for immediate use.
These procedures are a simple
version of the detailed proce-
dures listed in the manual. Next
to each procedure heading is a
convenient page number refer-
ence for the detailed procedure.
Should you have any difficulty
with these simple procedures,
refer to the pages listed for more
information.
It is highly recommended that
you take the time to read
through this manual to get the
most from your new TOSHIBA
facsimile.
- QUICK START
Press: , ,
SET TERMINAL ID
ID NAME =(MAX 40)
Displayed for 2 seconds
Enter your user ID (company
name) using the Keyboard (see
page 36) and Numeric Keypad,
press:
INT. CODE?
1.ADD+
2.NOT NEEDED
If you communicate internation-
ally, select:
Otherwise, select:
Enter your facsimile’s telephone
number, press:
If the Line-2 board is installed,
set the international code and
facsimile’s telephone number for
line-2.
OPERATION COMPLETED
Displayed for 2 seconds
1.LANGUAGE
2.DATE & TIME
3.TERMINAL ID
4.DIAL TYPE
Terminal ID
Setting the Terminal ID (Page 42)
1
SET TERMINAL ID
TEL NUMBER (MAX 20)
Press:
Your TOSHIBA facsimile has
been preset from the factory to
receive facsimile messages. No
special setup is required to re-
ceive facsimile messages.
Load your document face down
into the Document Tray.
Dial the remote facsimile using
the Dial Keypad located on the
Operation Panel. Remember to
include any access numbers
such as 9 or press the
af-
ter the access number if you
normally have to wait for a dial
tone.
After the remote facsimile num-
ber has been entered using the
keypad, press the green START
key.
MAY-17-00 WED11:49
RESIDUAL MEMORY 100%
ENTER TEL NUMBER
Transmitting
Receiving
Sending a Facsimile
(Page 101)
2
Receiving a
Facsimile (Page 112)
3